To Next Page
A
Anna MurilloSep 7, 2025
What if valves are worn out in WAGNER Wildcat 10-70?
- JJesse RoachSep 7, 2025
If the valves, packings, or pistons are worn out in your WAGNER Water Pump, replace the parts.
What if valves are worn out in WAGNER Wildcat 10-70?
If the valves, packings, or pistons are worn out in your WAGNER Water Pump, replace the parts.
What if WAGNER Water Pump stops at the stroke end?
If your WAGNER Water Pump stops at the stroke end, check the detent element.
What if there is foreign body in suction valve of WAGNER Water Pump?
If there is a foreign body in the suction valve of your WAGNER Water Pump, dismount the suction valve housing, and clean and check the valve seat.
What to do if WAGNER Wildcat 10-70 does not work and there is no pressure indication?
If the WAGNER Water Pump isn't working and there's no pressure indicated on the pressure gauge, it could be that the air pressure regulator is defective. Try briefly disconnecting the compressed air supply. If that doesn't work, you may need to repair or replace the pressure regulator.
Why is my WAGNER Wildcat 10-70 Water Pump spray jet collapsing?
If your WAGNER Water Pump's spray jet collapses, causing pulsation, it might be due to several reasons. One possibility is that the viscosity of the spraying product is too high; in this case, thin the spraying product. Another reason may be that the spraying pressure is too low, so you should increase the incoming air pressure or use a smaller nozzle. Also, check if the valves are clogged, and if so, clean the pump, soaking it in cleaning agent if needed. Ensure that the control air filter or work air filter is not clogged, and clean it if necessary.
What to do if WAGNER Water Pump runs but does not suck up any product?
If the WAGNER Water Pump runs evenly but doesn't suck up any product, the issue might be a loose union nut in the suction system, causing the pump to take in air. Tighten the union nut to resolve this. Another potential cause is a clogged suction filter, which you should clean. Also, check if the ball in the suction or piston valve is stuck; if so, clean the balls and valve seats.
General| Inlet/Outlet Size | 1 inch |
|---|---|
| Power Source | Electric |
| Voltage | 230 V |
| Type | Submersible |
| Inlet/Outlet Diameter | 25 mm |
