EasyManua.ls Logo

WAGNER EvoMotion 40-15 - User Manual

WAGNER EvoMotion 40-15
72 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
II 2G IIB c T3/T4 X
B_04119
Translation of the Original
Operating Manual
Piston Pump
Flow Rate 15
cm
3
Version 12/2015

Table of Contents

Questions and Answers

  • B
    Bruce MelendezAug 3, 2025
    Why the air motor of WAGNER EvoMotion 40-15 Water Pump is iced up?
    • R
      rickyjonesAug 3, 2025
      If the air motor of your WAGNER Water Pump is iced up, it's likely due to a lot of condensation water in the air supply. Install a water separator to resolve this issue.
  • I
    imillerAug 15, 2025
    What to do if WAGNER Water Pump runs but does not suck up any product?
    • J
      Jeffery BooneAug 15, 2025
      If your WAGNER Water Pump is running smoothly but not sucking up any product, it could be due to a loose union nut on the suction system, causing the pump to take in air. Tighten the union nut to resolve this. Another cause might be a clogged suction filter, so clean the filter. Also, the ball in the suction or piston valve might be stuck; in this case, clean the balls and valve seats.
  • M
    Michele MirandaAug 21, 2025
    Why WAGNER Water Pump spray jet collapses (pulsation)?
    • L
      Linda HarrisAug 21, 2025
      If the WAGNER Water Pump has irregular operation and the spray jet collapses (pulsation), several factors could be responsible. The viscosity of the spraying product might be too high, so thin it. The spraying pressure could be too low, so increase the incoming air pressure and consider using a smaller nozzle. Also, the valves might be clogged, so clean the pump, soaking it in solvent if necessary. A foreign body in the suction valve could also be the cause; dismantle the suction valve housing, and clean and check the valve seat. Ensure the diameter of the compressed air line isn't too small. If valves, packings, or pistons are worn out, replace them. Finally, check the pressure regulator filter and clean it if necessary.
  • E
    epowellAug 27, 2025
    Why does WAGNER Water Pump run when the gun is closed?
    • C
      Chad LewisAug 27, 2025
      If your WAGNER Water Pump continues to run even when the gun is closed, it's likely that the packings, valves, or pistons are worn out and need replacement.
  • A
    Amber GarrisonNov 9, 2025
    What to do if my WAGNER EvoMotion 40-15 does not work?
    • A
      Amy BarreraNov 9, 2025
      If your WAGNER Water Pump isn't working, several factors could be at play. The air motor might not be functioning or could be stopping. Try opening and closing the ball valve on the pressure regulator unit, or briefly disconnect the compressed air supply. Another possibility is that there's no pressure indication on the pressure gauge due to a defective air pressure regulator; in this case, briefly disconnect the compressed air supply or repair/replace the pressure regulator. Also, the spray nozzle or filter insert in the spray gun might be clogged, so clean them. Ensure there's sufficient compressed air supply. If the fluid section or high-pressure hose is blocked, dismount and clean the fluid section and replace the high-pressure hose. Finally, if the pump stops at a switching point, pre...

Summary

About These Instructions

Warnings, Notices and Symbols in these Instructions

Highlights dangers to users and the device, and states measures for avoiding hazards.

Correct Use

Use in an Explosion Hazard Area

Details the conditions and zones for operating in explosive atmospheres.

Safety Parameters

Outlines essential safety parameters and conditions for operation.

Identification

Explosion Protection Identification

Explains the ATEX certification and device suitability for explosive areas.

Identification X

Details specific identification marks related to safe operation.

General Safety Instructions

Safety Instructions for the Operator

General safety rules for the person operating the device.

Electrical Equipment

Safety requirements for electrical devices and equipment.

Personnel Qualifications

Specifies the necessary qualifications for operating staff.

Safe Work Environment

Ensures a safe and static-dissipative working environment.

Safety Instructions for Staff

General safety rules for all staff involved with the device.

Safe Handling of WAGNER Spray Devices

Instructions for safely handling spray devices and avoiding injuries.

Grounding the Device

Explains the importance and procedure for grounding the device.

Product Hoses

Requirements and checks for product hoses and their connections.

Cleaning and Flushing

Safety measures for cleaning and flushing the device.

Handling Hazardous Liquids, Varnishes and Paints

Precautions when working with hazardous materials.

Description

Data

Technical Data

Continues the presentation of technical specifications and parameters.

Pressure Regulator Unit

Safety and Motor Pressure Relief Valve

Describes the safety and pressure relief valve for the air motor.

Assembly and Commissioning

Grounding

Detailed instructions and diagrams for proper grounding.

Commissioning

Operation

Safety Instructions

General safety instructions before carrying out work.

Emergency Stop

Procedure for using the emergency stop function.

Spraying

Steps and considerations for the spraying process.

Pressure Relief;Work Interruption

Procedures for relieving pressure or during work interruptions.

Cleaning and Maintenance

Maintenance

Product Hoses, Tubes and Couplings

Troubleshooting and Rectification

Repair

Spare Parts

AIR MOTOR

Details the air motor and its spare parts.

FLUID SECTION 15

Details the fluid section and its spare parts.

Warranty and Conformity Declarations

WARRANTY CLAIM

Details the warranty terms and conditions for the device.

WAGNER EvoMotion 40-15 Specifications

General IconGeneral
BrandWAGNER
ModelEvoMotion 40-15
CategoryWater Pump
LanguageEnglish

Related product manuals