43
OPERATING MANUAL
VERSION 12/2015
ORDER NUMBER DOC2333558
B_03918
1. Check the level of separating agent in the separating agent cup every day, and top
up if necessary.
2. Check and clean the high-pressure lter every day or as required (see Chapter 8.2.8.).
3. Every shut down should be carried out as laid down in Chapter 8.1.3!
4. Check hoses, pipes, and couplings every day and replace if necessary.
If the pump has to be emptied for maintenance work, proceed according to
Chapter8.2.6.
The service manual is available in German and English.
For order number see Chapter 1.3.
8.2.3 REGULAR MAINTENANCE WORK
8.2.4 FILLING SEPARATING AGENT
Place the supplied separating agent into the separating agent cup.
Filling level: 1 cm; 0.4 inch under the cup edge.
Separating agent: Order no. 9992504
Inclination angle of the pump
Maximum permissible inclination of pump for moving, transportation,
etc. after lling it with separating agent ±30°.
The pump must be vertical during operation.
Piston pump dry run!
High wear/damage to the packings.
Paint or solvent can escape if the seals are dry.
Ensure that the separating uid tank is lled with su cient separating uid. Filling
level 1 cm; 0.4 inch under the cup edge.
NOTICE
To Next Page
Loading...
Need help?
General
