33
OPERATING MANUAL
VERSION 12/2015
ORDER NUMBER DOC2333558
7 OPERATION
7.2 SAFETY INSTRUCTIONS
Incorrect operation!
Risk of injury and damage to the device.
If contact with lacquers or cleaning agents causes skin irritation,
appropriate precautionary measures must be taken, e.g.,
wearing protective clothing.
The footwear worn by operating sta must comply with
EN ISO 20344. The measured insulation resistance must not
exceed 100 megohms.
The protective clothing, including gloves, must comply with
EN ISO 1149-5. The measured insulation resistance must not
exceed 100 megohms.
WARNING
Before carrying out any work, the following points must be observed in accordance with
the operating manual:
Observe all safety regulations in accordance with Chapter 4.
Carry out commissioning in accordance with Chapter 6.6.
7.1 TRAINING THE OPERATING STAFF
The operating sta must be quali ed and t to operate the entire system.
The operating sta must be familiar with the potential risks associated with improper
behavior as well as the necessary protective devices and measures.
Before work commences, the operating sta must receive appropriate system training.
Unintentional putting into operation!
Risk of injury
Before any work on the device, in the event of work interruptions
and malfunctions:
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
Switch o the energy/compressed air supply.
Disconnect the control unit form the network.
In the event of functional faults: remedy the fault as described in
the "Troubleshooting" chapter.
WARNING
To Next Page
Loading...
Need help?
General
