10
OPERATING MANUAL
VERSION 12/2015
ORDER NUMBER DOC2333558
2.5 PROCESSIBLE WORKING MATERIALS
Abrasive working materials and pigments!
Greater wear of parts carrying the product.
Do not use any grainy and abrasive working materials with large, sharp-edged
pigments.
Use the application-related model ( ow rate/cycle, material packaging, valve seat,
etc.), as speci ed in Chapter 5.5.
Check if the uids and solvents used are compatible with the pump construction
materials as indicated in Chapter 5.5.1.
NOTICE
Wear caused by abrasive working materials is not covered by the warranty.
Application
Water-based products
Solvent-based products
Low viscosity (<40 sec. DIN No. 4)
Medium viscosity (40 to 60 sec. DIN No. 4)
High viscosity ( >60 sec. DIN No. 4)
UV - sensitive products
Shear sensitive products
Humidity sensitive products
Legend
recommended limited suitability less suitable
To Next Page
Loading...
