WAGNER EvoMotion 40-15 - Maintenance; Safety Instructions

42
OPERATING MANUAL
VERSION 12/2015
ORDER NUMBER DOC2333558
8.2 MAINTENANCE
Maintenance work should be undertaken regularly and carefully by quali ed and trained
sta . They should be informed of speci c hazards during their training.
The following hazards may arise during maintenance work:
- Health hazard from inhaling solvent vapors
- Use of unsuitable tools and aids
An authorized person must ensure that the device is checked for being in a reliable state
after maintenance work is completed.
8.2.1 MAINTENANCE STAFF
8.2.2 SAFETY INSTRUCTIONS
Observe the safety instructions in Chapter 4 and Chapter 8.1.2.
Prior to maintenance
It should be ensured that the device is in the following state before carrying out any work
on it:
- Release pressure from the pump, high-pressure hose and gun.
- The gun should be secured with the safety clip.
- The air supply should be interrupted.
After maintenance
- Commissioning in accordance with Chapter 6.6.
In accordance with DGUV regulation 100-500 (BGR 500 Chapter 2.29 and 2.36):
- The liquid ejection devices should be checked by an expert (e.g., WAGNER service
technician) for their safe working conditions as required and at least every
12months.
- For shut down devices, the examination can be suspended until the next start-up.
Incorrect maintenance/repair!
Danger to life and equipment damage.
Repair or replacement of devices or parts of devices are only
allowed to be performed outside the hazard area by quali ed
personnel.
DANGER