www.velobike.co.nz
5. Gently slide on the
adapter. Make sure the
spline is fully engaged.
7
4. Behind the free-hub is
a spacer, remove this and
set it aside. We will use
this again when installing
the fixed gear adapter.
6. Place the free-hub
spacer that we had set
aside (step 4) onto the
axle in-front of the Fixed
gear adapter.
Note: Tolerance variations
in the Kickr’s spline may
make the adapter feel too
tight or too loose. Try a
few positions until you
find one that feels firm
with the least amount of
play.
To Next Page
Loading...
