Need help?Do you have a question about the Walfront UDB1002 and is the answer not in the manual?
Details waveforms, amplitude, impedance, DC offset, display, resolution, stability, accuracy, distortion, linearity, rise/fall time, and duty range for signal output.
Specifies the frequency range, amplitude, and fan-out for the TTL output signal.
Outlines the counter range, frequency meter range, and input voltage range for the counter function.
Describes the frequency range and sweep time parameters for the sweep function available in UDB100xS models.
Covers the save and load parameter functionality, allowing storage and recall of device settings.
Guides users on selecting frequency adjustment, adjusting position, and switching units (Hz, kHz, MHz) for frequency settings.
Details how to adjust functions like Wave, Duty, Counter, Save, Load, Time, Sweep, and External Frequency.
Explains the adjustment of duty cycle for Square and Triangle waveforms, including sawtooth variations.
Describes the counter function operation and the external frequency measurement capability.
Details the operation of Save, Load, Time setting, and Sweep functions, including parameter setup.
Covers synchronized TTL output and the use of potentiometers for amplitude and DC offset adjustments.
General| Model | UDB1002 |
|---|---|
| Category | Signal Processors |
| Impedance | 50Ω |
| Sine Wave Frequency Range | 0Hz~2MHz |
| Waveform Types | Sine, Square, Triangle |
| Amplitude Range | 0 to 10Vpp (High Impedance) |
To Next Page