6
ITEM PART DESCRIP TION NO.
NO. NO. REQ’D
ITEM PART DESCRIP TION NO.
NO. NO. REQ’D
Use only genuine Walker
®
replacement parts. Effective Date 12-01-00
BODY ASSEMBLY (GHS 9.5 BUSHEL MODELS)
Body Assembly (GHS 9.5 Bushel Models Only)
*
1 5566 Tilt Stop Strap 2
2 5516-15 Rear Bumper (9.5) MC Twin 1
3 7516-5 Catcher Pivot Bushing 2
4 5162 Roller Wheel (5") 2
5 7517-2 Catcher Pivot Plate 2
6 5845 Rubber Bumper (1.50 OD x 1.25) 1
7 5516-10 Bumper Mount (C-Twin) 2
Fasteners
F002 10-24 Keps Nut 4
F009 5/16-18 Whiz Locknut 5
F012 3/8-16 Keps Nut 2
F013 3/8-16 Whiz Locknut 2
F014 3/8-16 ESNA Nut 2
F026 10-24 x 1/2 PPHMS 2
F027 10-24 x 5/8 PPHMS 2
F034 5/16-18 x 3/4 Hex Bolt 4
F042 3/8-16 x 2-1/4 Hex Bolt 2
F059 3/8 Wave Spring Washer 2
F085 3/16 Rivet Backup Washer 2
F087 #10 x 7/8 Fender Washer 4
F151 3/8-16 x 7/8 Hex Bolt 2
F213 3/4-10 Jam Nut 2
F241 .375 x .875 x .10 Washer 4
*
Rear Bumper Assembly for GHS 6.7 Bushel Models is not
shown here. Refer to BODY / CHASSIS ASSEMBLY (GHS
MODELS), Page 4. Rear Bumper Assembly for SD Models is
not shown here. Refer to BODY ASSEMBLY (SD MODELS),
Page 8.
NOTE: Refer to BODY / CHASSIS ASSEMBLY (GHS MODELS),
Page 4 for all common parts used on both GHS and SD
models.
To Next Page
Loading...
