- 11 -
Using Side AV Connectors
You can connect a range of optional equipment to
your LCD TV.
For connecting a camcorder, connect to the VIDEO •
IN socket and the AUDIO SOCKETS. For selecting
the related source, see the section “Input selection”
in the following parts.
To listen the TV sound from headphones, connect •
to the HEADPHONE jack of theTV.
Using Other Connectors
You can connect a range of optional equipment to your
TV. Possible connections are shown below. Note that
cables shown in the illustration are not supplied.
For connecting to a device that has SPDIF support, •
use an appropriate SPDIF cable to enable sound
connection.
External Speakers
A device that
supports
SPDIF signal.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of •
the handset by gently pulling backwards from the
indicated part.
Insert two • AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it will not be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC, 50 Hz. •
Switch the “• ” button to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch the TV on from standby mode either:•
Press the “•
” button, CH “ ” / CH “ ” or a numeric
button on the remote control.
Press the • -P/CH or P/CH+ touch button on the TV. The
TV will then switch on.
Note: If you switch on your TV via CH “
” / CH “
” buttons on the remote control or on the TV set,
the programme that you were watching last will be
reselected.
To Switch the TV Off
Switch the “• ” button to position 2 as illustrated,
“
” so the TV will switch OFF.
To power down the TV completely, unplug the •
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.
01_MB65_[GB]_DVB-TC_PVR_BRONZE18_1910UK_42843W_10076242_50202610.indd 1101_MB65_[GB]_DVB-TC_PVR_BRONZE18_1910UK_42843W_10076242_50202610.indd 11 04.11.2011 11:18:4604.11.2011 11:18:46
To Next Page
Loading...
Need help?
General
