Walkera V450D01 - Instructions for RX2702 V Receiver; Channel Connection of Receiver

2
5 INSTRUCTIONS FOR RX2702V RECEIVER
5.3 CHANNEL CONNECTION OF RECEIVER (FOR MODE 2 USERS ONLY?)
CAUTION: Please note that when using a MODE 2 transmitter set-up PIT and AILE servos are inverted
compared to the original manual. There are 2 options to correct this:
1) Physically move the servos in the helicopter frame
2) Switch the AILE and PIT servo channel plugs on the receiver
Failing to make this switch will make the system appear to move as if using a mix of transmitter modes.
If your transmitter is set to MODE 2, it will appear to operate as if in MODE 1 for PIT & ELEV but in MODE 2 for
throttle. (i.e. Max ELEV & Max THROTLE are on the same channel! Your helicopter will be uncontrollable.)
PIT
AILE