37
Location Lubricate Hinges & Pivot Points
C
Hood Deflector
d
Discharge Chute Swivel
Every 100 hrs or annually, wash
and clean wood chipper, remove
entangled material, wood chips,
small debris.
D
C
Location Grease Points - 50 hrs or Annually
2
Rotor Main Shaft Rear Roller Flange
Grease with one shot of grease
2
8 Hours or daily, all models, grease
PTO Lubrication Points
(see Driveline Maintenance 7.2.1)
40 Hours or weekly
grease PTO
telescoping section
Models BX52, BX72, BX102 Series - Continued
To Next Page
Loading...
