Wangen KL 30 Series User Manual

Instruction Handbook KL
Chapter 10
BA KL V11 en 10/2014 page 10-1
Replacement Parts Stock 10
10.1 Replacement parts
Wear and thus the service life of the major pump components is significantly influenced by various
different factors such as;
 operating pressure,
 speed of rotation,
 condition of the delivery medium,
duration of plant operation.
The most important replacement parts that you should normally keep in stock for each pump in order
to achieve low MTTR values (mean time to repair) are listed in the table below (recommendations
according to DIN 24 296).
Number of alike pumps per plant part
Replacement parts
up to 3 pumps
from 4 pumps onwards
stator
1
2
rotor
1
2
set of seals (O ring)
1
2
cardan shaft (complete) (*)
1
2
shaft seal (*)
1
2
joint / sealing oil (*)
1
2
(*) depending on type of pump ( data sheet)
Possible damage
 Use exclusively original WANGEN replacement part, so that the operability of the pump
will not be impaired.
10.2 Replacement part orders
When ordering replacement parts always quote
 pump type and
 pump number!
The required details can be found in the pump type plate. In addition, the pump number is stamped
into the top of the bearing chair near its transition to the suction casing. We shall not be liable in any
way for any incorrect deliveries due to the details provided being inaccurate.
Direct replacement part orders at the following address:
Pumpenfabrik Wangen GmbH, Telephone: 0049-7522/997-0
Simoniusstraße 17, Fax: 0049-7522/997-108
D - 88239 Wangen Email: mail@wangen.com
ATTENTION

Wangen KL 30 Series Specifications

General

Brand	Wangen
Model	KL 30 Series
Category	Water Pump
Language	English