Why are changes to WAREMA Control Systems unit parameters not executed by the bus devices?
If changes to the unit parameters are not executed, it's likely that changes made in the service mode were not transferred to the bus devices. To resolve this, reload devices and remedy any faults, if applicable.
What to do if WAREMA Control System product cannot be operated with the control panel?
If you cannot operate the product with the control panel, examine and remedy fault causes related to the actuator power supply. If a safety function is active, wait until the cause (precipitation, wind, ice) is no longer present. If a wind test identified a fault, reset the wind test.
How to fix WAREMA Wisotronic not responding to an EWFS Hand-held transmitter?
If your Wisotronic isn't responding, first ensure the transmitter has been learned in. If you're using an 8-channel EWFS transmitter, verify that you've selected the correct channel and then repeat the move command. Also, ensure you press the button long enough and reduce any distance to Wisotronic. If a safety function is active, wait until the cause (precipitation, wind, ice) is no longer present, or reset the wind test if it identified a fault.
What to do if there are uncontrolled movements of WAREMA Wisotronic Control Systems connected products?
If you experience uncontrolled movements, it might be because changes were made to the bus parameters but not transferred to the bus devices; in this case, reload the devices. Alternatively, a temporary power failure/restart may have occurred, requiring a calibration after the power is restored.
What causes uncontrolled movements of products connected to WAREMA Wisotronic Control Systems?
If the connected products experience uncontrolled movements with your WAREMA Control Systems, it may be due to a temporary power failure. A power failure must be followed by a calibration.
What to do if my WAREMA Wisotronic Control Systems product cannot be operated with the control panel?
If your WAREMA Control Systems product cannot be operated with the control panel, several factors could be at play. First, a fine-wire fuse in the actuator might be faulty. Examine and remedy any fault causes. Second, a safety function may be active due to precipitation, wind, or ice; in this case, wait until the weather condition subsides. Finally, the wind test may have identified a fault; if so, reset the wind test.
What does the "Fault" display in the WAREMA Wisotronic heading mean?
If you see a "Fault" display in the heading of your WAREMA Control Systems, open the fault table and read out the cause. If necessary, inform a specialist dealer.
Why does my WAREMA Wisotronic Control Systems sun shading system move up too late in cloudy weather?
If the sun shading system moves up too late in cloudy weather with your WAREMA Control Systems, the HIGH limit value might be set too high (sun control). Change the limit value.
Why is the sun shading lowering when there's little sunshine with my WAREMA Wisotronic Control Systems?
If the sun shading is lowered when there is little sunshine with your WAREMA Control Systems, the "Delay DOWN" limit value may be set too low (sun control). Change the limit value.
Why is the sun shading lowering too late in sunshine with my WAREMA Control Systems?
If the sun shading is lowered too late in the sunshine with your WAREMA Control Systems, the "Delay LOW" limit value may be set too high (sun control). Change the limit value.
General| Brand | WAREMA |
|---|---|
| Model | Wisotronic |
| Category | Control Systems |
| Language | English |
To Next Page
