To Next PageTo Next Page
Need help?Do you have a question about the WarmPool EASYPAC 35 and is the answer not in the manual?
Check unit condition upon receipt and report issues within 48 hours for claims.
Installation must be by qualified personnel to avoid warranty loss or damage.
Verify the status of inlet, outlet, and bypass valves before operation.
Clean the filter weekly to ensure optimal functioning of the unit.
Adjust bypass, inlet, and outlet valves to specific settings for operation.
Decreases compressor speed, potentially affecting performance.
Change operating mode and access parameter settings.
Turn the unit on/off, cancel operations, or return to the last mode.
Scroll through operating and temperature parameters using up/down buttons.
Displays for cooling, heating, automatic, and defrosting modes.
HP pressure switch detects high refrigerant pressure. Contact customer service.
LP pressure switch detects low refrigerant pressure. Contact customer service.
Faulty flow sensor contact. Check calibration, connections, and clean sensor.
HP&BP pressure switches detect anomaly due to low refrigerant. Contact after-sales service.
No connection between control box and heat pump. Check wiring or replace control box.
Malfunction of water inlet temperature sensor. Check probe, cable, or replace sensor.
Malfunction of water outlet temperature sensor. Check probe, cable, or replace sensor.
Malfunction of ambient air temperature sensor. Check probe, cable, or replace sensor.
Malfunction of evaporator temperature sensor. Check probe, cable, or replace sensor.
Significant temp difference or PCB malfunction. Check valves, sensors, flow, or replace PCB.
Malfunction of suction temperature sensor. Check probe, cable, or install resistor.
Contact technical service for F-code faults.
Clean the evaporator fins regularly with a water jet for optimal airflow.
Unclog condensate outlets to prevent water accumulation and corrosion.
Winter storage is mandatory at the end of the season to prevent exchanger freezing.
Disconnect electrical power and water lines, close valves.
Unscrew connections, empty the hydraulic system, leave space.
Do not touch the operating fan to avoid injury. Keep appliance away from children.
Regularly check power supply and connection cables for safety.
Use only manufacturer's original parts for after-sales service.
General