Overview
Operator’s Manual 21
1
Using the Warming System
Overview
This chapter provides information on operating the WarmTouch™ Model WT-5900
patient warming system.
Power Supply Cord
Plug the warming system power cord into a hospital grade or suitable mains
outlet.
Main Power
WARNING
No free-hosing. Keep hose nozzle connected to a WarmTouch™ blanket at all
times or thermal injury may occur.
WARNING
Thermal injury may occur if the warming system hose comes into contact
with the patient.
Power is controlled through one main rocker switch located on the front of the
warming system. To begin operation, press the Main Power switch to the ON
position. The Low temperature light on the control panel illuminates, the
warming system begins blowing low temperature air, and the power fail alarm
sounds. Press the desired temperature key to cancel the alarm.
To Next Page
Loading...