Warn 79234 - Tools Required; Torque Specifications

WARN INDUSTRIES PAGE 2 79235A0
©2007 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
II. TABLE OF CONTENTS
Tools Required page 2
Torque Specifications page 2
Parts List page 3
Installation page 4-6
Maintenance/Care page 7
Tips/Troubleshooting page 7
Caution
MoMo
MoMo
Mo
ving Pving P
ving Pving P
ving P
arar
arar
ar
ts Entanglement Hazardts Entanglement Hazard
ts Entanglement Hazardts Entanglement Hazard
ts Entanglement Hazard
FF
FF
F
ailure tailure t
ailure tailure t
ailure t
o obsero obser
o obsero obser
o obser
vv
vv
v
e these instructions could lead te these instructions could lead t
e these instructions could lead te these instructions could lead t
e these instructions could lead t
o minor or moderato minor or moderat
o minor or moderato minor or moderat
o minor or moderat
e injure injur
e injure injur
e injur
yy
yy
y
..
..
.
 Always take time to fully read and understand the installation and Operations Guide included with this product.
 Never operate this product if you are under 16 years of age.
 Never operate this product when under the influence of drugs, alcohol or medications.
Read installation and operating instructions thoroughly.
Notice
Equipment Damage
 Always refer to the Installation and Specification Guide, supplied in the winch kit, for all wiring schematics and specific
details on how to wire this WARN product to your vehicle.
 Never overtighten the j-bolt to the bracket. Doing so will pinch the winch cable against the bracket, damaging the cable.
 Always put the end of the actuator cable through the slot in the Termination Bracket. Terminating the cable through any other
hole in the bracket will cause the bracket to not function properly and will drastically reduce the life of the actuator cable.
Read installation and operating instructions thoroughly.
IV. TORQUE SPECIFICATIONS
Grade 8.8 Only
M6 10.5 N-m (8 lb. ft.)
M8 26 N-m (17 lb. ft.)
M10 51 N-m (30 lb. ft.)
M12 89 N-m (50 lb. ft.)
M14 141 N-m (75 lb. ft.)
III. TOOLS REQUIRED
- RATCHET
- 1/2”, 13mm, 15mm SOCKET
- 1/2”, 13mm, 15mm WRENCH