Warner Electric MCS-203

Need help?

Do you have a question about the Warner Electric MCS-203 and is the answer not in the manual?

Summary

Installation Guide

General Installation Procedures

Control Housing Installation

Panel Mounting Procedures

System Wiring Procedures

Wiring Precautions and Safety

MCS-166 to MCS-203 Wiring

Detailed wiring instructions for connecting the MCS-166 power supply to the MCS-203 dancer control module.

MCS-166;MCS-204 System Wiring

Instructions for wiring the MCS-166 power supply to the MCS-204 remote/analog control module.

MCS-204 Input Configuration Options

Voltage and Current Input Setup

Procedures for configuring MCS-204 inputs using voltage or current sources, including calibration steps.

System Start-Up and Adjustment (MCS-166;MCS-203)

Static Adjustment and Check Out

Procedures for performing static checks and initial adjustments on the MCS-166/MCS-203 system before dynamic operation.

Machine Start and Dancer Stabilization

Steps for starting the machine, drawing material, and stabilizing the dancer's position for optimal performance.

P-I-D Gain Adjustments

System Start-Up and Adjustment (MCS-166;MCS-204)

Preliminary Set-Up Procedures

Initial setup steps for the MCS-166/MCS-204 system, including voltage selection and module installation.

Static Adjustments and Check Out

Input Calibration Procedures

Dynamic Adjustments

Troubleshooting MCS-203 Systems

Dancer Movement Issues

Dancer Erratic Movement Issues

Troubleshooting MCS-204 Systems

Power and Brake Engagement Issues