EasyManuals Logo

Waterdrop WD-AS08 User Manual

Waterdrop WD-AS08
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Step 5. Connect Tubing (Figure 7)
1. Install the Inlet Water Tubing
Connect the inlet water tubing from the feed water adapter to the inlet water port and pop the
lock clip on the tting;
2.Install the Outlet Water Tubing
Connect the outlet water tubing from the faucet to the outlet water port and pop the lock clip on
the tting;
Step 6. Check the Leaks and Flush the Filter
Turn on the cold water supply valve. Check if there’s water leakage at connectors, components,
valve or any connecting position. Then turn on the faucet. It may dispense muddy or black water
at the beginning. Please ush for 10 minutes continuously.
Note: The water is not drinkable until ushing for 10 minutes.
Cartridge change instructions
Step 1. Remove the Old Cartridge
Turn o the water supply to the system. Open faucet to release the pressure and drain the water.
Unscrew the fastening ring using the lter wrench included with your system. Hold the lter head
with one hand and pull o the cartridge with another hand. Remove and discard the old lter
cartridge.
Step 2. Install the New Cartridge
Hold the lter head with one hand and insert the cartridge into the head with another hand until
two black sealing rings are fully inserted and the cartridge reaches the end.
Press the lter head downwards hard into the housing. Then screw the fastening ring counter-
clockwise with a wrench. Hang the bracket on the screws.
Step 3. Flush the System
Turn on the cold water supply valve and check if there’s water leakage. Then turn on the faucet. It
may dispense muddy or black water at the beginning. Please ush for 10 minutes continuously.
Frequently asked questions
Q: What should I do if water leaks after installation?
A: In the event of water leakage, turn o the water supply. If the water leakage is occurring at the
thread, wrap Teon tape on the external thread. If the water leakage is occurring at the quick
connect position, check whether the cut of PE tubing is at. If it is not at, re-cut the tubing. Also
make sure the tubing hits the bottom of the tting. Contact us for solutions if the water leakage
persists.
Close
Inlet Hose
ColdHot
Outlet Hose
Filter system
Faucet hose
Figure 7
Inlet Outlet

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Waterdrop WD-AS08 and is the answer not in the manual?

Waterdrop WD-AS08 Specifications

General IconGeneral
BrandWaterdrop
ModelWD-AS08
CategoryWater Filtration Systems
LanguageEnglish

Related product manuals