Waterford 104 MK II User Manual

104 MK II WOOD-BURNING STOVE
SAFETY NOTICE
PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR NEW ROOM HEATER. FAILURE TO
FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH. SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
IF THIS STOVE IS NOT PROPERLY INSTALLED, A HOUSE FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW THE
INSTALLATION DIRECTIONS. CONTACT LOCAL BUILDING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND
INSTALLATION IN YOUR AREA.
THIS STOVE MUST BE CONNECTED TO A LISTED HIGH TEMPERATURE RESIDENTIAL TYPE AND BUILDING HEAT-
ING APPLIANCE CHIMNEY OR AN APPROVED MASONRY CHIMNEY WITH FLUE LINER.
MANUFACTURED BY: WATERFORD STANLEY (MARKETING) LIMITED
BILBERRY, WATERFORD, IRELAND.
INSTALLATION AND OPERATING INSTRUCTIONS

Waterford 104 MK II Specifications

General

Type	Wood Stove
Efficiency	75%
Fuel Type	Wood
Max Log Length	18 inches
Flue Size	6 inches
Heating Area (sq. ft.)	1, 500 sq. ft.

Summary

Safety Notice

General Safety Warnings

Failure to follow instructions may result in property damage, bodily injury, or death.

Installation Guidance and Local Codes

Follow installation directions and consult local officials about restrictions and area requirements.

Chimney Connection Requirement

Stove must connect to a listed high-temperature residential type or approved masonry chimney.

General Instructions

Chimney Requirements

Connect to a properly sized chimney; avoid shared chimneys and specific vent types.

Chimney Connector

Connector Material and Installation

Connecting to Masonry Chimney

Masonry Chimney Pass-Through Requirements

Chimney Connector Systems, Thimbles, and Clearances

System 1: Brick Masonry Wall Clearances

System 2: Insulated Chimney Length

System 3: Ventilated Thimble

System 4: Pass-Through Section

Masonry Fire Place

Fireplace System Inspection

Connecting to Masonry Chimney

Ventilation & Combustion Air Requirements

Outside Combustion Air

Air Circulation Methods for Wall Protectors

Chimney Cleaning

Cleaning Procedure

Installations Clearances

Clearances to Combustibles

Details required clearances from the stove, flue pipe, and connector to combustible materials.

Reduced Clearances

Reduced Clearances with Shields

Details reduced clearances using listed stove shield and pipe shield.

Double Wall Chimney Connectors

Wall Protectors

Wall Protector Installation

Installing wall protectors according to listing conditions and manufacturer instructions.

Air Space for Wall Protectors

Floor Protection

Floor Protector Specifications

Details material thickness, coverage area, and extension for floor protectors.

104 MK II - Operation

Primary Air Settings

Lighting the Stove

Reloading and Burn Rate Adjustment

Safety Precautions

Warnings about unattended operation, combustible material placement, and fuel storage.

Creosote and Chimney Maintenance

Fire Safety

General Fire Safety Measures

Installation of smoke detectors, fire extinguishers, and evacuation plans.

Chimney Fire Procedure

Steps to take in the event of a chimney fire.