Waterford Trinity Mk II User Manual

SAFETY NOTICE
Please read this entire manual before you install and use your new room heater. Failure to follow instructions
may result in property damage, bodily injury or even death.
If this stove is not properly installed, a house fire may result. For your safety, follow the installation directions.
Contact local building or fire officials about restrictions and installation inspection requirements in your area.
This stove must be connected to a UL/U.L.C. listed High Temperature residential chimney, Factory Built,
Residential Type and Building Heating Appliance, UL 103 or a code approved masonry chimney flue liner
constructed in accordance with NFPA 211 Chimney Vents and Solid Fuel Burning Appliances
Manufactured by Waterford Stanley (Marketing) Limited, Bilberry, Waterford, Ireland.
INSTALLATION & OPERATING INSTRUCTIONS
TrinityMk II
WOODBURNING STOVE

Waterford Trinity Mk II Specifications

General

Brand	Waterford
Model	Trinity Mk II
Category	Stove
Language	English

Summary

Pre-Installation Assembly

Prepare Ashpit and Firebox

Remove contents from ashpit door and firebox, and clear firebox.

Remove Hob and Pallet

Remove hob and wooden pallet from the stove base.

Fit Front Ashlip and Handle

Attach front ashlip and wooden handle to the stove.

Fit Side Fuelling Door Components

Install side ash lip, door latch, and handle for side fuelling door.

Flue Exit Options

Top Flue Exit

Instructions for connecting the flue to the top outlet.

Rear Flue Exit

Instructions for connecting the flue to the rear outlet.

Blower Operation

Blower Installation

Steps for fitting the optional blower assembly.

Operation Instructions

How to operate the blower, including switch and temperature controls.

Installation Location and Clearances

Floor Protection

Requirements for floor protection material and dimensions.

Location Considerations

Factors for selecting a suitable location for the stove.

Outside Air Connection

Connecting the stove to an outside air supply for combustion.

Mobile Home Installation

Mandatory requirements for installing the stove in a mobile home.

Clearance Requirements

Minimum Clearances to Combustibles

Table of minimum distances from stove to combustible materials.

Reduced Clearances

Conditions and methods for reducing minimum clearances.

Wall Protectors

Installation of wall protectors for clearance reduction.

Chimney and Connector Systems

Chimney Requirements

Specifications for connecting to a chimney, including size and type.

Chimney Connector Systems, Thimbles, and Clearances

Details on various systems for chimney connectors and wall penetrations.

Fireplace and Ventilation

Masonry Fireplace Installation

Guidelines for installing the stove with a masonry fireplace.

Ventilation & Combustion Air Requirements

Ensuring adequate combustion air supply and preventing backdrafts.

Operation and Maintenance

Lighting the Stove

Step-by-step guide for lighting the fire.

Primary Air Settings

Adjusting the primary air control for maximum and minimum burn.

Low or Overnight Burn

Tips for achieving a long-duration or overnight burn.

De-Ashing

Procedure for removing ash when the fire has burned out.

Cleaning and Safety

Disposal of Ashes

Safe handling and disposal of ashes.

Creosote Formation and Removal

Understanding creosote and its removal to prevent fires.

Glass Replacement

Instructions for safely replacing the stove's glass panel.

Vitreous Enamel Cleaning

Care instructions for maintaining the stove's enamel finish.

Fire Safety Guidelines

General fire safety considerations, including detectors and extinguishers.

In the Event of a Chimney Fire

Procedure to follow in case of a chimney fire.