EasyManua.ls Logo

Waterpik Water Flosser WF-03 User Manual

Waterpik Water Flosser WF-03
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Insert
1
3 4 5
2
English
1. Remove reservoir. 2. To remove battery
door, twist, and pull.
3. Insert 3AA batteries.
Included.
4. To replace battery
door, line-up arrows,
push
and
twist.
5. Insert tip
firmly until
it clicks into
place.
6. Fill reservoir with
warm water.
Slide power switch to low(l)
or high(ll) position. Start
with lowest setting and
increase to your liking.
Close lips enough to
prevent splashing, while
still allowing water
to flow from mouth
into the sink.
Aim water at the gumline
at a 90° angle. Follow the
gumline and pause briefly
between teeth.
TO AVOID MESS: PLACE THE
TIP IN YOUR MOUTH BEFORE
TURNING
UNIT ON
Register your product and
receive over $50 in savings.
waterpik.com/registration
Visit
waterpik.com/VID03
QUICK START GUIDE
Review full instruction book prior to first use.
FIRST USE
START WATER FLOSSING
© 2017 Water Pik, Inc.
1.800.525.2774 (USA) 1.888.226.3042 (Canada)
TECHNIQUE HOW TO VIDEOLEAN OVER SINK
Model WF-03
Question and Answer IconNeed help?

Do you have a question about the Waterpik Water Flosser WF-03 and is the answer not in the manual?

Waterpik Water Flosser WF-03 Specifications

General IconGeneral
ModelWF-03
ColorWhite
Warranty3 years
Pulse-Modulation TechnologyYes
TypeWater Flosser
Tips Included2 Tips

Summary

First Use Instructions

Remove Reservoir

Remove the water reservoir from the unit before proceeding with setup.

Battery Compartment Access

Twist and pull the battery door to remove it for battery installation.

Install Batteries

Insert three AA batteries into the compartment as indicated.

Secure Battery Door

Align arrows on the battery door, push, and twist to secure it.

Insert Flossing Tip

Firmly insert the flossing tip into the handle until it clicks into place.

Fill Reservoir

Fill the reservoir with warm water before using the device.

Start Water Flossing Process

Avoid Mess: Mouth Placement

Place the tip inside your mouth before activating the unit to prevent splashing.

Select Power Setting

Operate the power switch to low or high. Begin with the lowest setting and adjust as preferred.

Lean Over Sink

Proper Body Posture

Maintain a seal with your lips to prevent splashing, allowing water to drain into the sink.

Flossing Technique

Aiming and Movement

Direct the water stream at the gumline at a 90° angle, pausing briefly between teeth.

How to Watch Video Guide

Access Instructional Video

Watch instructional videos by visiting waterpik.com/VID03 for guidance.

Product Registration

Register your product at waterpik.com/registration to receive savings and support.

Related product manuals