TO AVOID MESS: KEEP TIP IN MOUTH WHILE UNIT IS ON.
This device is compatible with global voltages of 100 - 240 VAC, 50/60 Hz.
Register your product and
receive over $50 in savings.
waterpik.com/registration
Visit waterpik.com/welcomeWF
to watch How To Video
©2019 Water Pik, Inc.
Unit Prep
1
Water Floss
2
WF-10
QUICK START GUIDE
A. Plug power cord into
outlet and connect the
charging cord to the unit.
A. With unit OFF, place tip in
mouth. Turn power ON. Start
on low pressure, by pressing
the power button once. Press
twice for high pressure.
B. Press tip firmly into unit,
until it clicks into place.
To remove tip, push the tip
eject button.
C. Disconnect charging cord
from unit. Lift the flip top on
reservoir and fill with warm
water. Refill as needed.
B.
Lean over sink. Close lips
enough to prevent splashing.
Keep unit upright during use
to ensure continuous water
flow.
C. Aim water at the gumline
at a 90 degree angle. Follow
the gumline and pause
briefly between teeth.
Low
OFF
Plug
Charge Unit for
4 Hours Prior to
First Use.
Fill
Insert
Caution:
Do not press
tip eject
button while
unit is running.
To Next Page
Need help?
General
