What to do if my Watlow QPAC-01 Control Unit has no output?
If your Watlow Control Unit has no output, there are several potential causes. First, check and replace any blown fuses. Also, check the transformer connections. The SCR(s) will not function without a load, so ensure the load wiring is correctly connected. Finally, verify the temperature control output is correct.
What to do if Watlow QPAC-01 Control Unit output is uncontrolled full ON?
If the output of your Watlow Control Unit is uncontrollably full ON, the issue might stem from several components. Try unplugging the control card and check if the issue persists. Also, unplug the transformer wire and try again. If full ON or half ON output is still present with no control card and no transformer, the power base is likely faulty and needs replacement.
Why is my Watlow QPAC-01 transformer hot?
If the transformer in your Watlow Control Unit is overheating, the cause might be an incorrect transformer. Check both the product and transformer labels to ensure they match.
What to do if heatsink temperature exceeded 187°F (86°C) in Watlow Control Unit?
If the heatsink temperature of your Watlow Control Unit exceeds 187°F (86°C), the issue might be a clogged or non-operational fan. Check the fan and its power supply, and clean it if necessary. Also, check for a shorted thermostat and replace the fan or thermostat as needed. Note that the #27-0005 thermostat is normally open and closes when the temperature rises.
General| Model | QPAC-01 |
|---|---|
| Number of Zones | 1 |
| Output Type | Relay |
| Communication Protocol/Interface | RS-485, Modbus RTU |
| Temperature Range (Operating) | 0°C to 50°C |
| Temperature Range (Storage) | -20°C to 70°C |
| Relative Humidity | 10% to 90% non-condensing |
To Next Page
