Watlow Series 96 - Ordering Information

Active if output 4 is process (96 _
_- _ _ _ M -_ _ _ _) and Calibra-
tion Lock (Lockout Menu) is not
set to [hide].
1622 w10.00 (1000)0.00 to 99.99
[4`10] Output Calibra-
tion 4, 10V
Enter the output
value in volts as
measured.
Active if output 4 is process (96 _
_- _ _ _ M -_ _ _ _) and Calibra-
tion Lock (Lockout Menu) is not
set to [hide].
1621 w1.00 (100)0.00 to 99.99
[4``1] Output Calibra-
tion 4, 1V
Enter the output
value in volts as
measured.
Active if output 4 is process (96 _
_- _ _ _ M -_ _ _ _) and Calibra-
tion Lock (Lockout Menu) is not
set to [hide].
1620 w20.00 (2000)0.00 to 99.99
[4`20] Output Calibra-
tion 4, 20mA
Enter the output
value in milliamps
as measured.
Watlow Series 96 Calibration ■ 11
Display Parameter Range Default Modbus Conditions for
(Modbus Value) Address Parameters to Appear
Read/Write
Ordering Information (1551)
Series 96
9 6
——
–
————
–
————
Microprocessor-based
1
/16 DIN with universal input 1.
Options include software, power supply,
input 2, four outputs and display color
Power Supply
A = 100-240Vı (ac/dc)
B = 24-28Vı (ac/dc)
Input 2
0 = None
1 = Event input & 0-5VÎ (dc)/
4-20mA (remote set point input)
Output 1
C = Switched dc/open collector
D = Electromechanical relay, Form C,
2A, without RC suppression
F = Universal Process, range selectable: 0-20mA,
4-20mA, 0-5VÎ (dc), 1-5VÎ (dc), 0-10VÎ (dc)
K = 0.5A solid-state relay without
RC suppression
Output 2
A = None
C = Switched dc output/open collector
D = Electromechanical relay, Form C, 2A, without RC suppression
F = Universal Process, range selectable: 0-20mA,
4-20mA, 0-5VÎ (dc), 1-5VÎ (dc), 0-10VÎ (dc)
K = 0.5A solid-state relay without
RC suppression
Output 3
A = None
D = Electromechanical relay, Form C, 2A, without RC suppression
Output 4
A = None
D = Electromechanical relay, Form C, 2A, without RC suppression
R = 232 Communications
U = 485 Communications
M = Universal Retransmit, range selectable: 0-20mA,
4-20mA, 0-5VÎ (dc), 1-5VÎ (dc), 0-10VÎ (dc)
Software/Preset Parameters
00 = Standard software
AA = Ramping
Display/Overlay
Upper/Lower
RR = Red/Red display GR = Green/Red display
RG = Red/Green display GG = Green/Green display