2 ■ Calibration Watlow Series 96
Table of Contents
Calibrating the Series 96.......................................................3
Thermocouple Input Procedure.............................................4
Voltage Process Input Procedure .........................................5
Current Process Input Procedure .........................................5
Process Output Procedures..................................................6
Calibration Parameters .........................................................8
Ordering Information ...........................................................11
How to Reach Us .................................................Back Cover
Warranty, Returns.................................................Back Cover
Technical Assistance
If you encounter a problem with your Watlow controller, see the Trouble-
shooting Table in the Appendix of the Series 96 User’s Manual and review all
of your configuration information to verify that your selections are consistent
with your application: inputs; outputs; alarms; limits; etc. If the problem
persists after checking the above, you can get technical assistance from your
local Watlow representative, or by dialing (507) 454-5300, ext. 1111.
An applications engineer will discuss your application with you.
Please have the following information available when calling:
• Complete model number • All configuration information
• User’s Manual • Diagnostic menu readings
Your Feedback
Your comments or suggestions on this manual are welcome. Please send them
to: Technical Writer, Watlow Controls, 1241 Bundy Blvd., P.O. Box 5580,
Winona, MN 55987-5580; phone: (507) 454-5300; fax: (507) 452-4507. The
Series 96 Calibration Manual is copyrighted by Watlow Winona, Inc., ©
January 1999, with all rights reserved. (1627)
To Next Page
Loading...