Setup
Press the [ Set button1] shortly and operate the same way as for the
YEAR setting to finish the setting of the month value (range 01 - 12).
Step 4 • Setting Mode - Setup for the DAY
After you press [ Down button3] to confirm the setting of MONTH and
then will enter into day setting interface. The default setting is [ 01 ] and the
symbol [ D ] is flashing (Fig. 5).
Fig. 5
Press the [ Set button1] shortly and operate the same way as for the
YEAR setting to finish the setting of the day value (range 01 - 31).
To confirm the setting of MONTH, press [ Down button3].
To modify the MONTH, please press the [ Set button1] again to re-
start the MONTH setting.
To confirm the setting of DAY, press [ Down button3].
To modify the DAY, please press the [ Set button1] again to restart
the DAY setting.
Setup
Press [ Set button1] to confirm and you will see that the hundred - digit
of the year begins to flash.
Do the same way until you set the correct value of the last single - digit.
After you set the last single - digit, press the [ Set button1] shortly to
confirm. The confirmation of the last single digit will make the complete 4
digits number flash (Fig. 3).
Step 3 • Setting Mode - Setup for the MONTH
After you press [ Down button3] to confirm the setting of YEAR and then
will enter into month setting interface. The default setting is [ 01 ] and the
symbol [ M ] is flashing (Fig. 4).
To confirm the setting of YEAR, press [ Down button3].
Fig. 3
To modify the YEAR, please press the [ Set button1] again to restart
the YEAR setting.
Fig. 4
8 9
Continue setting on the next page.
To Next Page
