EasyManua.ls Logo

Watts Premier RO-TFM-5SV - User Manual

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Page 1
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
DELUXE PLUS
WATTS PREMIER 25
ULTRA 5
RO-TFM-4SV
RO-TFM-5SV
PUR-TEK
Refer to enclosed warranty for operating parameters to ensure proper use with your water supply.
Watts Premier, Inc. 1725 W. Williams Drive C-20 Phoenix, AZ 85027
Phone: 800-752-5582 www.wattspremier.com Fax: 623-931-0191
Save manual for future reference
MODELS
Warning
Please read carefully before proceeding with installation. Your failure to follow any attached instructions
or operating parameters may lead to the product’s failure and possible damage to property.
System tested and certified by NSF International against NSF/
ANSI Standard 58 for the reduction of the claims specified on the
performance data sheet.
Manual Edition: 04/03/07
P/N 199348
EPA / ETV
Test verified
performance

Questions and Answers

  • N
    Nicole LaneAug 4, 2025
    What to do if Watts Premier Water System filter housing leaks?
    • E
      Emma ThompsonAug 4, 2025
      If water leaks from the blue/white filter housing: * Ensure the bowl is properly tightened. * If there is a kinked o-ring: Turn off the water supply and release the pressure. Replace the o-ring if necessary. Lubricate it and make sure it is seated properly in the filter bowl before reinstalling.
  • L
    Linda BowenAug 8, 2025
    Why is my Watts Premier Water System producing water slowly?
    • T
      Todd KeyAug 8, 2025
      Several factors can cause low or slow water production. Check the following: * Ensure incoming water pressure is at least 40 psi. If it's too low, Watts Premier sells a booster pump. * Confirm the water supply is on and the Adapta Valve is fully open. * Inspect tubing for crimps and straighten or repair them. * Replace clogged pre-filters. * Replace the membrane and Flow Restrictor if the membrane is fouled.
  • M
    Misty ClarkAug 12, 2025
    What to do if Watts Premier Water System constantly running and won't shut off?
    • K
      Katie LopezAug 12, 2025
      If your system won't shut off, there are several potential causes: * Low water pressure: Ensure a minimum of 40 psi incoming water pressure. * Crimp in supply tube: Inspect the tubing and straighten or repair as necessary. * High water pressure: Verify that the incoming water pressure does not exceed 80 psi. A pressure relief valve may be required. * High pressure in: Empty the storage tank of water and set the tank air pressure to 5 psi.
  • D
    davidclarkAug 16, 2025
    Why does my Watts Premier Water System faucet leak from the airgap feature?
    • C
      carlsonalbertAug 16, 2025
      Airgap faucet leaks can occur due to: * A crimp in the drain line: Check the tubing. * A restriction in the drain line: Straighten all drain lines, clear any blockages, and cut off any excess tubing. * A clogged drain tube: This is often caused by the dishwasher or garbage disposal. Disconnect the 3/8" black line at the drain, clean it out with a wire, and then reconnect it. Blowing air through the line may not always remove the clog.
  • W
    wilsonlindsayAug 21, 2025
    Why is my Watts Premier Water System making noise from the faucet or drain?
    • E
      Eileen NelsonAug 21, 2025
      Noise issues can stem from a few sources: * Air gap faucet: The sound is inherent with air-gap faucets. * Location of drain saddle: Check the diagram for proper location of the drain saddle. * Restriction in drain tube: Clear any blockage that may be caused by debris from the garbage disposal or dishwasher. * High water pressure: A pressure regulator is required if the pressure exceeds 80 psi.
  • D
    Derrick VasquezAug 26, 2025
    Why is there a small amount of water in my Watts Premier Water System storage tank?
    • J
      Jason RiceAug 26, 2025
      A small amount of water in the storage tank could be due to: * System just starting up: It normally takes 6-10 hours to fill the tank. Low pressure and/or temperature can drastically reduce production rate. * Low water pressure. * Excessive air in the tank bladder: Tank pressure is set at the factory and should be 5 psi when empty. Add air if below 5 psi and bleed air if above 5 psi. Check only when the tank is empty.
  • W
    wnguyenAug 29, 2025
    Why is the water from my Watts Premier Water System milky colored?
    • Y
      ycrawfordAug 29, 2025
      Milky colored water is often due to air in the system. This is normal when initially starting up the RO system and should disappear within 1-2 weeks of normal use. If it reoccurs after filter changes, drain the tank 1 to 2 times.

Summary

Limited Warranty Terms

Warranty Coverage Details

Specifies covered defects and the warranty duration for the RO system components.

How to Obtain Warranty Service

Outlines the procedure for contacting support and returning the unit for warranty claims.

Warranty Exclusions and Limitations

Lists conditions and damages not covered, including misuse, neglect, and external factors.

Other Warranty Conditions

Covers aspects like reconditioned parts, warranty period for repairs, and transferability.

Consumer Rights Under State Law

Informs users about their specific legal rights and how they may vary by state.

Watts Premier RO-TFM-5SV Specifications

General IconGeneral
Product TypeReverse Osmosis Water Filtration System
Stages of Filtration5
Membrane TypeThin Film Composite (TFC)
Water Production Rate50 gallons per day
Dimensions15 x 14.5 x 5 inches (system), 15 x 11 inches (tank)
Weight25 pounds
Membrane Life2-3 years
Storage Capacity4 gallons
Included FiltersSediment filter, Carbon block filter, RO membrane, Post carbon filter
Warranty1 year limited warranty
Filter Life6-12 months

Related product manuals