EasyManuals Logo

Watts AERCO Benchmark OMM-0136 Installation And Start-Up Manual

Watts AERCO Benchmark OMM-0136
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 3 ONAER SETUP
OMM-136_H • GF-210 1/6/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 47 of 62
SECTION 3: onAER SETUP
3.1 INTRODUCTION
AERCO has developed new connectivity capabilities to make its IoT offering, onAER, easier for
its broad customer base to implement. The onAER feature lets AERCO boilers be monitored
remotely. As in the past, AERCO has taken precautions to make onAER secure for both the
customer’s heating equipment and networks.
All Benchmark Platinum boilers include AERCO’s onAER feature.
onAER communication can be established in one of two ways:
Through an Ethernet cable from the site’s network. This is plugged into the Ethernet
jack in the left side of the Edge Controller.
Wirelessly via Wi-Fi. This solution requires the purchase and installation of the optional
AERCO Wi-Fi module (P/N 24526-1). This module is then connected directly to the
boiler’s I/O board, eliminating the need for an Ethernet cable.
The sections below provide instructions for implementing only the first option, enabling
communication through an Ethernet cable connected to the site’s network. If you ordered a
Benchmark Platinum boiler with the Wi-Fi module, it is included in a separate container inside
the unit’s shipping container. The instructions for installing both the Wi-Fi module are in
Technical Instruction document TID-0178, included with the Wi-Fi module.
If you did not order the Wi-Fi module but are now interested in it, contact your AERCO
representative and ask about purchasing the Wi-Fi module (P/N 24526-TAB).
Before onAER can be used, it must be enabled. Go to: Main Menu Advanced Setup
Comm & Network onAER.
Figure 3-1: onAER Screen
1. Set the onAER Mode parameter to one of the following:
Ethernet: Requires an Ethernet cable to plugged into the Controller. See next section,
below.
Wi-Fi: Requires the AERCO Wi-Fi module (P/N 24526-TAB) to be installed on the unit;
see the onAER Wi-Fi Module Installation Guide (TID-0178) for instructions.
Wiznet: This option intended for units on which the Edge Controller was installed as a
replacement for the C-More Controller.

Other manuals for Watts AERCO Benchmark OMM-0136

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Watts AERCO Benchmark OMM-0136 and is the answer not in the manual?

Watts AERCO Benchmark OMM-0136 Specifications

General IconGeneral
BrandWatts
ModelAERCO Benchmark OMM-0136
CategoryBoiler
LanguageEnglish

Related product manuals