Watts AERCO Benchmark OMM-0137 - Connecting the Ethernet Cable

Benchmark Platinum-Edge [ii]: Installation Manual
SECTION 3 – ONAER SETUP
OMM-136_H • GF-210 • 1/6/2021 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 48 of 62
2. Once enabled, the following additions parameters appear:
• Unit Upload Time: Determines how frequently unit data will upload to the server, in
seconds. This will be split between unit data and cascade data (Manager unit only).
(Range: 30 to 9999)
• Cascade Upload Time: Determines how cascade data will upload to the server, in
seconds. (Range: 60 to 9999)
• Status: Displays the communication interface status, which varies depending on the
interface selected in Step 2.
3.1.1 Connecting the Ethernet Cable
Connecting the Ethernet Cable Instructions
1. Connect a CAT 5 or better Ethernet cable to the wall jack or box provided at the site.
2. Route the Ethernet cable to the left side of the Edge Controller, avoiding hot locations.
3. Plug the Ethernet cable into the Edge Controller’s Ethernet jack (see Figure 3-1).
Figure 3-2: Edge Controller – Left Side View
ETHERNET
JACK