Installation & Wiring
1 Place the MILUX thermostat (A) on a plain wall away from windows and doors and not to close to the heater.
Put the connection wires (B) thru the back hole of the rear part. Use the screws (C) to mount the rear part on the wall.
2 Connect the wires to the connector (D).
Follow the connection diagram
3 Remove the plastic isolator on the batteries to power up the
MILUX. Then close the MILUX as explained in step 3 of
the batteries replacement (last page)
4 Adjust the time and follow the QUICK START instructions
DIM
Instructions
To Next Page
Loading...
Need help?
General
