Page 11
OPERATION
Start up Instructions
Congratulations! You have completed the installation of your new water filtration system. Please Follow the
Startup Instructions.
Step 1: Turn on water supply at angle stop and open the Adapt-a-Valve. Turn
faucet handle to the open position to start the flow of water through the
unit. Run 3 gallons of water through the unit in order to flush out the
normal black carbon fines (it will “sputter” until the air is purged out)
from the unit. Initially, the water may appear cloudy which is due to tiny
air bubbles and it will clear up shortly. Close the faucet when finished.
Step 2: Check for leaks. If you have any leaks, shut off the water supply to your
system, tighten any fittings / housings and restart unit.
NOTICE
Check frequently over the next 24 hours to ensure no leaks are present
To Next Page
Loading...
