English
Specifications
• 2.1 channel stereo sound system
• 3 built-in amplifier channels, headphones amplifier
• Wired remote control with controls for VOLUME level and ON/STANDBY, including terminals
for line-in (2) and headphones (STREAMPORT: with additional Bluetooth function)
• BASS/TREBLE control, line-in (1) and mains power switch at the subwoofer back
• Connections by audio cables
• Frequency range: 30 - 150 Hz (subwoofer); 150 – 20,000 Hz (satellites)
• Output power (RMS): 50W (30W + 2x 10W)
• Mains tension: 100-240V 50/60HZ, 0.5A max.
• Dimensions (WxHxD): satellites 8,2 x 17,8 x 9,8 cm, Subwoofer 18 x 28 x 26,5 cm
• System requirements: analogue stereo source with 3.5 mm phono socket or RCA sockets
CE - Declaration of conformity
We herewith declare, that the wavemaster MX3+ system complies
with the following standards or normative documents:
EMC Directive (2004/108/EC)
EN55013:2001 +A1:2003 +A2:2006, EN55020:2007 +A11:2011
LVD Directive (2006/95/EC)
EN60065:2002 +A1:2006 +A11:2008 +A2:2010 +A12:2011
This statement is based on the test reports of an EMV - laboratory.
All texts and illustrations were produced with greatest care. wavemaster cannot however accept
any legal or other responsibility for any remaining incorrect information and its consequences.
Subject to change without further notice.
In case there is audible noise, possibly caused by strong radio waves (e.g. by mobile
phones) we recommend to turn down the volume control of the unit.
If you have special questions to the product and cannot find a solution in this introduction, you
can look for more informations at our homepage. Thank you!
www.wavemaster.eu
8
1-01
$-
!"#!$
(&)$$$
1%0
$+10
-20-
0
To Next Page
Loading...
