Mono-to-Stereo and Stereo
Mono-to-Stereo Stereo
The Mono-to-Stereo and Stereo Amps share the same controls and graphic user
interface, but their input and processing specifications are different.
Mono-to-Stereo is very similar to the Mono DualCab component, but outputs a
Stereo signal. Rather than adding each cabinet’s output to a single path you can
pan them to create a Stereo image from the Mono input.
The Stereo Amp component is actually a dual-Mono configuration which takes a
Stereo input and outputs Stereo. The Left input goes through the Amp type to
cabinet 1 and the Right input goes to cabinet 2. The Pan control can be used to
limit the Stereo image width, collapse the Stereo input to a Mono output, or swap
the channel outputs by hard panning them in opposite directions.
Waves GTR Amp User Guide
15
To Next Page
Loading...
