LOADING PRESETS AND SETUPS
Click-and-hold on the Load button to see the Load pop-up menu. The menu is
divided into four sections. If a section is not currently available it will not appear in
the Load pop-up menu.
Open Preset File… Select to open any setup or preset file, whether from the
Library or your own creations.
‘Filename.xps’: Displays any currently loaded Setup File and its presets.
Factory Presets: Displays the default Factory Presets.
User Presets: Displays any loaded User Presets.
SAVING PRESETS AND SETUPS
Click-and-hold on the Save button to see the Save pop-up menu. Four options
are available. If an option is not currently available it will be grayed out and
inaccessible.
Save to New File… Select this to start a new Setup file. There are
two prompts - first for the setup filename, then
for the preset name. You must provide a name
for both the setup file and the preset. Click OK
(ENTER) to complete the save. It is a good
idea to create a folder in which to save several
setup files for a project.
Save ‘File Name’ – “Preset Name” Overwrites the settings of the loaded preset
(whether a User Preset or a preset from a
Setup File) with the current settings. If a Setup
File is currently loaded, the name of the Setup
File is displayed followed by the name of the
preset itself. If a User Preset is loaded, its
name is displayed.
Save to ‘File Name’ As… Saves the current settings as a new preset into
the Setup file that is open (if one is not open,
the option is grayed out). You will be prompted
to give the preset a name.
Put into Preset Menu As… Save the current settings into a User Preset
that will always be in your Load menu (until
deleted). You will be prompted to give this
Waves GTR Amp User Guide
17
To Next Page
Loading...
