Safety Precautions
Notice
Please reserve the following information for
future use.
Caution
To prevent AlphaBot2, a precision device, from breaking down or being
damaged, please follow the requirement listed below.
The product employs two series 14500 batteries for power supply with input
voltage of 7.4V. When working with Arduino and Raspberry Pi at a same time,
the external power supply should be applied. Any external power supply has to
obey to the regulations and standards of power supply for your area.
The product should be applied under a well-ventilated environment, to
guarantee the heat dissipation of power supply and product performance.
The disassembly chassis should be placed on the stable, flat and
non-conducting surface, without touching any conductive materials.
Installing the incompatible device to the chassis may cause damage and void
the warranty.
The product should not expose to water and moisture, or not be placed on
conductive surface, in the course of any operations.
AlphaBot2 should not touch any heat source, to make sure reliability service
under normal room temperature environment
To Next Page
Loading...
Need help?
General
