86 CHAPTER 9 CLICK 110
Location No No Yes
Device ID No No Yes
Fault Status No Fault Indicators Read-only
To use this
configuration feature:
Hardware Configu-
ration Mode
Software Configu-
ration Mode
Software Configu-
ration Mode
Table 9.1 – Click 110 Configuration Options
e nal row on the table refers to conguration modes. e DIP switches can be used to
choose between Hardware and Soware modes. If the switches are set to Hardware mode,
the DIP switches will be used to change conguration options. If the switches are set to So-
ware mode, the front panel menu and Click Supervisor will be used to change conguration
options. is will be discussed in greater detail in the DIP Switches section of this chapter.
Note
Any setting which has been configured via the DIP switches will be read-only in Click
Supervisor and the front panel menu.
DIP Switches
e DIP switches are located on the circuit board behind the faceplate. e side of the face-
plate contains information on conguring using the DIP switches, as shown in Figure 9.6.
To Next Page
Loading...
