Waydoo Flyer EVO - Page 39

Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
37
(2)Please carefully check the DC port on the top seat of the mast, the
middle support rod and the corresponding connection, the motor body, the
wing mounting hole, the wing mounting adapter, etc., to ensure that the
Power Unit will work without any difference or damage.
(3)Check the status of the grease on the sealing rings of the power port and
ESC port of the mast. Apply an appropriate amount of sealing ring lubricant
silicone grease to ensure lubrication and prevent rust.
(4)Please carefully check the propeller and protective cover, pin, motor
shaft and other PTO components to prevent corrosion or damage. If the
motor shaft or pin are corroded, it is recommended to use a rust remover
for cleaning and maintenance. If any part of the Power Unit is different or
damaged, please stop using it and contact the Waydoo After-sales Service
Team in time.
Cleaning and maintenance after use
(1)After using the eFoil, please make sure to turn off the battery completely
first. Then disassemble the battery, power unit, front and stabilizer wings
and place them in a safe and suitable place, preferably in a cool place.
(2)Please carefully check the overall appearance of the Power Unit,
propeller and other components to ensure that there is no obvious impact
or damage caused by use. If there is serious damage, please contact the
Waydoo After-sales Service Team in time.
(3)When cleaning the Power Unit, please rinse the main body of the mast
with fresh water for about 1 minute to ensure that there is no seawater or
other impurities left on the main body to prevent corrosion. Rinse the mast
top seat to ensure that the mast top seat is clean and free of debris. Rinse
and clean the DC port with fresh water, then wipe with alcohol swab to
ensure there is dry and free of debris. Clean the motor, propeller cover,
propeller and other places with fresh water to ensure any salt, sand or other
debris is removed.
(4)After fully cleaning the Power Unit, wipe it carefully with a dry towel, and
then place it in a dry and cool environment to remove the remaining
moisture.
(5)After drying, remove the propeller cover, propeller and propeller pin, and
check whether they are in good condition. If there is corrosion on the pin or
the motor shaft, it is recommended to use a rust remover for cleaning and
maintenance, and then install it back to the corresponding position.