Waydoo Flyer EVO - Ⅳ Assembly and Use; Waydoo Flyer EVO Assembly

Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
26
Ⅳ Assembly and use
4.1 Waydoo Flyer EVO Assembly
4.1.1 Inspection before assembly
1. Inspect the battery and mast power port terminals, ensuring that the
terminals are tight, with no signs of rust or debris. Loose terminals (which
can be tightened with tools), and abnormal appearance may cause severe
heating of the terminals, leading to deformation of structural components
and loss of waterproofness. It may also result in the overall battery life and
power performance decline.
2. Check the sensor ports between DC ports, ensure it is free of any water
and debris. Clean and dry it if necessary, otherwise the optical
communication function of sensor will be affected.
3. Please check the battery rotary lock pin, make sure it is located in the
groove.
4.1.2 Tool list
Slotted wrench, magnet, L-shaped wrench, electric screwdriver (optional)
Tips:
1. The L-shaped wrench is stored in the rubber plug of the battery
compartment of the board. Please put it back into the rubber plug after use.
2. The electric screwdriver is not waterproof. Please keep your hands dry