Waydoo Flyer EVO - Page 29

Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
27
when using it and avoid contact with water.
When the electric screwdriver locks the screw until it stops, the torque is
about 5N.m. Please turn the handle manually until the electric screwdriver
rotates by itself. When removing the screw, first turn the handle manually to
loosen the screw, and then use the electric function.
4.1.3 Prepare the components
Mast, Propulsion unit, Powerflight battery, Board, Front wing (including 3
M6X35 mounting screws), Stabilizer wing (including 2 M6X20 mounting
screws).
4.1.4 Assembly steps
Tips:
You can install the battery first or the mast first. If installing the mast first, it
is recommended to install the front wing and stabilizer wing before installing
the battery to ensure better support and stability during installation (if there
are no wings, brackets can be used to provide support).
1. Battery Installation
Note: Before installing, please make sure the battery compartment and DC
port is free of any water and debris. Check the sensor ports between DC
ports, ensure it is free of any water and debris. Clean and dry it if necessary,
otherwise the optical communication function of sensor will be affected.
1) Put the board on a flat ground with the Powerflight battery compartment
side facing up. Lift the Powerflight battery with both hands and put it into
the battery compartment carefully. Press Powerflight battery downward to
ensure it is fully inserted into the board.
Tips: It is recommended to put the tail of the battery into the battery
compartment first, and then install the battery handle side.
2) Use the slotted wrench on the remote wrist trap to press two round
rotary locks on Powerflight battery, and rotate them clockwise about 90
degrees to tighten them.