Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
3) Plug in the Rubber plug as shown below.
Note: An L-shaped wrench is placed here, please use it before plugging in
the Rubber plug.
Battery Removal
1. Rotate two battery rotary locks 90° counterclockwise with a slotted
wrench to the shown position.
2. Open the rubber plug, press the internal unlock switch, and lift the
battery upward with both hands simultaneously.
Note: Please follow the above instructions step-by-step to avoid damaging
the product.
2. Assemble the mast
1) Remove the three bolts that hold the rubber protective sleeve 1 on the
propulsion unit, then remove this sleeve. Next step is to remove the rubber
protective sleeve 2 locating at the connection of mast and propulsion unit.
Apply grease on the sealing ring according to the actual situation.
Note: Please keep the rubber protective sleeve properly to avoid loss.
To Next Page
Loading...
