Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
2) Remove rubber protective sleeve on the mast and masthead.
3) Insert the mast vertically downwards onto the propulsion unit. During
the installation, moving the mast slightly left and right will make it easier to
fit in place. Then fix and tighten it with two M6X20 bolts (Torque: 5-10N.m).
4) Turn the board over to insert the mast vertically into the mast installation
hub.
5) Ensure the mast is installed correctly, and tighten it with two M6X20
bolts (Torque: 5-10N.m).
Note: It is not recommended to frequently disassemble the mast and
propulsion unit to protect the connectors, and do not disassemble them
unless necessary.
3. Install the front wing and stabilizer wing
1) Put the front wing on the propulsion unit front mount, use three M6X35
bolts, tighten it with a L-shaped wrench or electric screwdriver, torque 5-10
N.m.
To Next Page
Loading...
