Waydoo Flyer EVO - Page 43

Waydoo Flyer EVO USER GUIDES
© 2024 All rights reserved by Waydoo
41
6. Wings
Tips
(1)Please use the screws in the official accessory package to install the wings.
Avoid screws that are too long or too short to install the wings in place and
damage the wings and wing adapters.
(2)The wings should be removed after each use and rinsed with fresh water
to avoid salt accumulation and corrosion of the mast caused by drying of
sea water.
7. Propeller
Regularly check the condition of the propeller. If your propeller is damaged
and needs to be replaced, please follow the below steps to replace it.
Tool: Flat wrench
1. Turn the propeller protective cover clockwise to remove it from the
propeller guard.
2. Remove the bullet. Unscrew it from the motor shaft with an Flat wrench,
and remove the current propeller.
3. Remove the current propeller pin and replace it with a new pin. Insert the
pin into the cross hole located on the propeller shaft at the motor output.
Center the pin on the motor shaft.
4. Reassemble the propeller: Take a new propeller (confirming that it has no
defects such as deformation or scratches), and assemble the propeller. Note
that the direction of the propeller groove should be consistent.
5. Reassemble the new bullet and the propeller protective cover, and the
propeller replacement is done.