344940 REV2 03/17/2020
©
Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation 25
Refer to gure #24. Depending on the width of the hood, extra supports may be required. If hood straps are provided, erect them now. To allow for thermal expansion, locate
the connecting screws in the bottom of the slots.
Attach the A.W. bracket housing and sandwich housing ange between bracket ange and front hood (see Figure #23). Check to insure the cut-outs, as provided, are large
enough so as not to interfere with either drop arm throughout its travel. Trim if necessary. Now tighten all screws in the vicinity of A.W. bracket. Attach the governor bracket
housing in similar manner and proceed to tighten all remaining hood screws.
Figure 24
Figure 23
To Next Page
Loading...