344940 REV2 03/17/2020
©
Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation 27
APPENDIX A: OPTIONAL COMPONENTS
MISCELLANEOUS FINAL CHECKLIST.
The following are some examples of common options and adjustments for re shutters:
SLIDE BOLTS OR CYLINDER LOCKS
Raise the shutter to the open position. Bend the tab on the inside of the guides so that it sticks out about 1/4”. Lower the shutter and try to engage the locks. If the bottom bar
contacts the tab before the door is completely closed, or the locks still do not engage the tab, bend the tab back in so that the casting just clears.
Appendix B: Service Record
This manual is intended for the use of the installer on the job site. It is meant to be informative but not exhaustive. The nal word is set out in the specications and drawings
approved by the purchaser before the door was shipped.
Wayne-Dalton doors should be installed by trained industrial door technicians. Wayne-Dalton dealers have access to technical training courses on rolling re door products.
This space is for comments regarding maintenance and service. The installer is asked to forward a note to Wayne-Dalton of any unusual facts or damage regarding the instal-
lation or shipment. This manual should be given to the building maintenance supervisor as a guide to maintenance and future repairs.
To Next Page
Loading...