11
Operating Instructions and Parts Manual
WSM3300
Quick Reference Cut-A-Way Card
CALL YOUR SYSTEM TO CHECK SYSTEM STATUS:
(no answering machine or digital voice mail service)
1. Make a phone call to the System (phone number at alarm location).
2. Wait for the System to answer (either five (5) or ten (10) rings).
3. Listen to the message(s). If no alarms, hang up.
4. If alarm(s) exist, cancel calls by pressing the "1" key then pound (#) key, hang up.
TO CANCEL A CALL FROM YOUR SYSTEM:
1. Listen to the message(s). If no alarms, hang up.
2. If alarm(s) exist, cancel calls by pressing the "1" key then pound (#) key, hang up.
CALL YOUR SYSTEM TO CHECK SYSTEM STATUS:
(answering machine/digital voice mail set to 4 rings, the System set to 5 rings)
1. Make a phone call to the System (phone number at alarm location), let ring three (3) times, hang up.
2. Make a second call to the System within 3 minutes, the System will answer on the second ring
(3 rings + 2 rings, System answers on fifth (5th) ring).
3. Listen to the alarm messages.
4. Press the "1" key then pound (#) key anytime during the message to acknowledge and cancel the alarm.
5. Note: if answering service answers before the System does, start over and adjust additive rings.
Copy, cut out and save the following Quick Reference Cut-A-Way Card for your records. These are especially useful when you are not at home
and need to contact the System to check the status, retrieve or cancel messages and alarms. It would also be useful to give this card to others
who are on the call notification list for your System.
www.waynepumps.com
To Next Page
Loading...
Need help?
General
