wayscral ANYWAY A2 - Regular Component Checks; Bicycle Servicing Schedule

54
Regular checks
Check the tightness of the bolts: lever, crank, pedals, stems.
The tightening torques to be applied are as follows:
COMPONENTS
RECOMMENDED TORQUE
(Nm)
SPECIAL INSTRUCTIONS
Pedals on crank arms
30 - 40
Lubricate the threads
Crank arm on bottom bracket
30 - 40
Lubricate the threads
Stem/handlebar tightness
6
Fork/handlebar tightness
8
Brake lever
6 – 8
Brake callipers
6 – 8
Seat
18 – 20
Seat post clamp
Quick clamp
Wheel
30-40
Quick clamp
The other tightening torques depend on the size of the nuts: M4: 2.5 to 4.0 Nm, M5: 4.0 to 6.0 Nm,
M6: 6.0 to 7.5 Nm. Tighten the screws evenly to the required torque.
Regularly check the tyres: wear, cuts, cracks, pinching. Replace the tyre if necessary. Check the wheel
rims for excessive wear, warping, denting, cracks, etc.
Servicing
For safety reasons and to keep the components in good working order, you should have your bicycle
regularly serviced by your retailer. Your bicycle should also undergo regular maintenance by a
qualified technician.
First service: 1 month or 300 km
• Check the components are properly tightened: crank arm, wheel, stem, pedals, stem, seat
clamp,
• Check the power assistance system is working correctly,
• Verification and brake adjustment,
• Tighten and/or straighten the wheels.
• Tyre pressure
Every year or 2000km:
• Check the wear levels (brake pads, gear system, tyres),
• Check the power assistance system is working correctly,
• Check the bearings (chain set unit, wheels, steering, pedals),