weasy SW45 - Environment

Thread keeps
breaking
Needle bent
Remove and re-insert a
new needle
Needle shank not properly
seated
Remove and re-insert a
new needle
Thread tension dial, thread
guide or thread pulling bar
too tight
Loosen the thread tension
between 3-5 number
Stitches too loose
or
uneven
Thread blocked by upper
bobbin
Pull out the spool pin and
make the bobbin or thread
run smoothly
Upper thread too tight or lower
thread too loose
Breaking needle Needle bent or deformed Remove and reinsert a
new needle
Presser foot too loose
Remove and reinsert a new needle
and screw tight
Pull fabric with force when
sewing
Remove and reinsert a new needle
and thread again
Needle not lowered into fabric
when start sewing
Remove and reinsert a new
needle, thread again, turn hand
wheel to lower the needle into
fabric, and then start sewing.
The instructions state the substance of
the following:
P
-
Switch off or unplug the appliance
when leaving it unattended
P
-Unplug the appliance before carrying
out maintenance or replacing lamps
P
ENVIRONMENT
CAUTION :
Do not dispose of this product as it has with other household products. There is a
separation of this waste product into communities, you will need to inform your
local authorities about the places where you can return this product. In fact,
electrical and electronic products contain hazardous substances that have harmful
effects on the environment or human health and should be recycled. The symbol
here indicates that electrical and electronic equipment should be chosen carefully,
a wheeled waste container is marked with a cross.
Adeva SAS / H.Koenig Europe - 8 rue Marc Seguin - 77290 Mitry Mory - France
www.hkoenig.com - sav@hkoenig.com - contact@hkoenig.com - Tél: +33 1 64 67 00 01