Webasto BlueCool V-Series - Page 24

24
Fault
code
Description Possible cause Correction
Display
n/a Sea water
pump(s) start
up directly after
the control is
switched on.
Wiring of pump
1 (sea water) and
pump 2 (cold wa-
ter) interchanged.
Please contact your au-
thorised Webasto Marine
dealer.
n/a Compressor
keeps cutting in
and out.
Too little cold water. Please contact your au-
thorised Webasto Marine
dealer.
n/a No or insu-
cient cooling
or heating
capacity.
Poor air or water
flow, soiled or circu-
lation blocked.
Secure adequate air or
water flow.
(see A01 and/or A02).
Refrigerant short-
age.
Please contact your au-
thorised Webasto Marine
dealer.
Oil lock.
Refrigerant circuit
blocked. (Filter or
expansion valve).
Compressor fault.
n/a Incorrect
cabin/ambient
temperature or
water tempera-
ture displayed.
Temperature
sensor positioned
incorrectly, subject
to interference
or display values
falsified.
Check whether the sensor
is subject to direct fault
sources such as direct
sunlight or devices radiat-
ing heat. Please contact
your authorised Webasto
Marine dealer.