www.webasto.us 69 Webasto Product N.A., Inc.
DBW 2010/2020/300 COOLANT HEATERS PRODUCT INFORMATION
Webasto Product N.A., Inc.• 15083 North Road • Fenton, Michigan 48430
For Technical Assistance in USA Call: (800) 555-4518 • In Canada Call: (800) 667-8900
Visit us on the Web at: www.techwebasto.com (North America) www.webasto.com (Global)
Page 3 of 3
Product Information
Description: ISS “WHITE” TIMER INSTALLATION / OPERATION INSTRUCTIONS
Category: Thermosystems
Document Number: PI007RC
Date Posted: 02/02/2007
Operation in manual mode:
The largest button on the timer is the “Manual” button. At the bottom of the “LCD” screen you will see a small line
that moves as you push this button. Underneath the small line you will see the corresponding function “On” “Auto”
“Off”. The manual button can be used as a toggle switch to operate the heater or after you have programmed the
timer for automatic service, push the manual button until the line is over “auto” on the timer. The timer will now turn
the heater on and off at the times preset earlier.
NOTE:
The toggle switch will illuminate green when the heater has an “On” signal. If the toggle switchisinthe
“Off” position and the timer has turned the heater on, the toggle will illuminate green. This is an easy
way to identify the heater is in operation. While the timer is “On” the toggle switch will NOT
operate
the heater. The toggle switch is a master switch whenever the timer is not in operation.
Safety Precautions:
• The heater must be switched off at filling stations and tank farms as aresult of the risk of explosion.
• The heater may not be operated in enclosedspaces (suchas garages)as aresult of the riskof
poisoning and asphyxiation, even if a timer is used.
• Wherever inflammable vapors or dust may form (for example in the vicinity of fuel, carbon, wood
dustorcereal stores or the like), the heater must be swit
ched off as aresult of the risk of explosion.
As with other devices whose activation is automated, if a particular
application presents a risk should the heater be automatically activated,
and suchavehicle or application is equipped with a “power cut off”
type switch which prevents devices from activating automatically, then
this timer/heater should be wired into this “power cut off circuit” to
ensure automated activation of the heater does not occur.
WARNING
To Next Page
Loading...
Need help?
General
